Logo SR Alpha 2017

Something amiss... seems very slow

More
13 years 5 months ago - 13 years 5 months ago #2928 by simmsimaging
Hey -
Just testing the newest build. I ran SR on part of a current job and was really surprised to see it running far slower than my default setup. I think something may be amiss in the settings somewhere?

It went from 30 seconds to over 14 minutes!

Here are three jpgs - my universal settings that I started with, then the SR using more or less default presets for "high" and "exterior Vray 2", and then one more with just default IM settings on high to verify that it wasn't just something with IM alone.

Seems very odd to me!

b

PS_ - The forum is insanely slow the last few times I tried to access it! Reminds me of the 14.4 modem days :)
Last edit: 13 years 5 months ago by simmsimaging.

Please Log in or Create an account to join the conversation.

More
13 years 5 months ago #2935 by subburb
Hi Brett,
damn bad news. ! same thing with the exterior_vray preset ?

you're right the forum is slow since i've upgraded from fireboard to kunena. works fine on chrome, but not into firefox. i'm investigating.

you problem comes only with Universal method, right ?

would you please try this special preset and have a try with it in association with univeral method ?

Please Log in or Create an account to join the conversation.

More
13 years 5 months ago #2938 by simmsimaging
That was with the exterior Vray preset - using the default IC/LM setup, sorry :) I will try this preset out now and get back to you.

(I am using Chrome btw: both it and Firefox are super slow on the forum for me).

/b

Please Log in or Create an account to join the conversation.

More
13 years 5 months ago #2939 by simmsimaging
With that preset it rendered in 2:08 minutes. Still slower, but much better than the LC/IM of 14 minutes. Still seems like something is off... I can send you the file if you want.

Please Log in or Create an account to join the conversation.

More
13 years 5 months ago #2940 by subburb
yep, if possible.
note that since Vray 2.0 SR activates the new LC option named "retrace corners" by default.

Perhaps it causes the problem (see options)

Please Log in or Create an account to join the conversation.

More
13 years 5 months ago #2941 by simmsimaging
I'll send a link via email.

I use retrace as a rule now as well, so I don't think that is it. Maybe you will see something obvious in the file.

/b

Please Log in or Create an account to join the conversation.

Time to create page: 0.202 seconds

Contact informations

Subburb

32, Rue theophile Gautier
33110 Le Bouscat
FRANCE

(+33) 6 73 03 72 29

Newsletter

Keep in touch with us

facebook_32 youtube_32 vimeo_32