RENDER SPECIFIED FRAMES...?

Hi, this is my 2nd attempt to post on this topic? This time as a "technical question".

> We just did a net render using our internal FARM, and for the most part everything on the shot came through very nice. However, a couple machines needed paths updated, or a plug-in to be updated as the renders shows a few frames here and there which are obviously missing maps, or a plug-in.

> I would like to specify the frames to be RE-RENDERED using FlyWiz? I do not see any option to specify frames in this way, as one would do using the MAX "common" render dialogue??

> Can this be done... I would hate to redo the full shot, as it is a day long render over 20 machines! And we have other shots to get to?! Any ideas would be greatly appreciated, and sooner is better than later...

Perhaps, once I get to Backburner... there will be an option? I will explore this, while I wait for anyone who may have come across this before...

I feel a bit silly holding this one sided conversation, but I will hold out hope that the others online have some experience with specify frame count options?

> I think as time is important, and it is a drag... but, I will simply submit multiple jobs to BB with one frame each for the problematic frames that need re-rendered?

Insane...

Hi,thanks for the additional information. Shortly after I posted, I found the answer to our questions within BB... thank goodness! The solution should anyone ever find themselves in the same situation where a NET RENDER was finished with one or 2 machines putting out bad frames due to a missing or out of date plug-in/map/etc... is; to within flywiz set your frame range with first and last frames... then submit to BB, once the BB interface launches you can specify specific frames to re-render (1,20,233,etc).

Solved...

best,

J