Latest build only renders GI and stops

Hi, this is really weird. I setup my presets with SR and apply and close it and then I render. All was ok but now after I installed the new SR my render stops after LC and IR. And "don't render only GI" is off!
Any ideas what's happening?

Sorry, it probably has nothing to do with SR. Latest tests show that the render stops when my VFB auto saves to file. Like vray can't start a file. It' says rendering and then done. Will investigate more.

Hey,
It seams that there is a problem with the latest built after all. At least on my system running vray 2.0x and MAX 2009.

I setup a test scene manually - GI and VFB to autosave the file. Than I used SR to set it up and also enabled VFB and autosave and then the render stopped after GI. I sent the scene to Chaos already. I can send it to you too if you want,

They only said
Unfortunately we can not give you any advise about SolidRocks since it is a third party software.
But in my opinion it just enables "Don't save final image option" (help.chaosgroup.com/vray/help/300R1/rend...witches.htm#indirect) for some reason or maybe you set Solid rocks to render an animation prepass with Irradiance map which only calculates the Irradiance map and save is on the PC. In this case it will only render the final image when you set Irradiance engine to Animation rendering. You can check that in the Irradiance map settings: help.chaosgroup.com/vray/help/300R1/rend...dvancedimap.htm#mode
If the animation Mode is set to Animation (prepass) after using Solid Rocks it is normal for V-Ray not to render the final image.

But, visibly, this doesn't appear to be the case. I mean if I look at my vray option after using SR, none of those are set - animation, or don't render....so no idea what's happening.